File Size: 51.7 MB
纯净峰IE是我们的立体声纯净峰限制器的精简版本，已经增强和优化了多声道环绕和“沉浸式音频”应用程序。纯净峰IE，像纯净峰一样，是一个超低失真峰值限制器，用于混音和母带应用，其中需要透明的峰值控制。
质朴的峰值IE可以支持多达12个通道的音频使用单声道一直到7.1.4通道为基础的音轨和总线。每个通道都可以调平+/-5dB预限幅器，同时它们的峰值也可以调平至低于主天花板设置的10dB。
通道隔离和旁路控制也提供了允许通道监控和总线分离。
纯净峰IE使用一种新颖的方法来动态控制，产生非常“干净”的声音，即使在高增益减少量下也不会破裂或扭曲。而不是饱和或裁剪波形峰值，原始峰值IE确定需要做什么来控制峰值，并将增益变化应用到整个波形。这导致非常低的THD非常“干净”的声音。
PristinePeaks IE提供以下特性
•多达12通道的独立增益降低
•在任何增益降低量（20Hz-20kHz）下，THD均小于0.005% *
•不混叠*
•-10dB至+20dB的预限制器全球驱动增益
•+/-5dB通道前置限幅器驱动器
•0 dB至-20dB全球上限范围
•0dB至-10dB通道天花板装饰
•+/-15dB电平输出控制
•选择两种不同的释放斜坡形状
•峰值保持仪表捕获最大增益降低•独立通道隔离和旁路按钮
*稳态测量
纯净的峰值IE是选择视频和多通道音乐制作应用程序的理想限制器，其中干净，高质量的限制是需要的，没有饱和或源材料的剪辑。注意：原始峰值IE需要相当多的延迟来“做它的事情”，因此，不适合实时/跟踪应用程序
Pristine Peaks IE is a streamlined version of our stereo Pristine Peaks limiter that has been enhanced and optimized for multi-channel surround and “immersive audio” applications. Pristine Peaks IE, like Pristine Peaks, is an ultra-low distortion peak limiter for use in both mixing and mastering applications where the transparent peak control is required.
Pristine Peaks IE can support up to 12 channels of audio for use on mono all the way up to 7.1.4 channel-based audio tracks and buses. Each channel can be level-trimmed +/-5dB pre-limiter while their peaks can be trimmed as well by as much as 10dB below the master Ceiling setting.
Channel Isolate and Bypass controls are also provided to allow channel monitoring and bus separations.
Pristine Peaks IE uses a novel approach to dynamics control that produces a very “clean” sound that does not break up or distort even at high gain reduction amounts. Instead of saturating or clipping waveform peaks, Pristine Peaks IE determines what needs to be done to control the peaks and applies that gain change to the entire waveform. This results in extremely low THD for a very “clean” sound.
PristinePeaks IE provides the following features
•Up to 12 channels of independent gain reduction
•Less than 0.005% THD at any gain reduction amount (20Hz-20kHz)*
•No aliasing*
•-10dB to +20dB of pre-limiter global Drive gain
•+/-5dB channel pre-limiter drive Trims
•0 dB to -20dB global Ceiling range
•0dB to -10dB channel Ceiling Trims
•+/-15dB level Output control
•Choice of two different release slope shapes
•Peak hold meters that capture the max gain reduction•Independent Channel Isolation and Bypass buttons
*Steady-state measurements
Pristine Peaks IE is the ideal limiter of choice for video and multi-channel music production applications where clean, high quality limiting is required without saturation or clipping of the source material. NOTE: Pristine Peaks IE requires a considerable amount of latency to “do its thing” and is, therefore, not suitable for live/tracking applications
